Hexagon Screen House 6.5 Ft.

87270

Step 1-
ASSEMBLE THE UPPER FRAME
LAY OUT CORNER PIECES
AND CONNECT WITH FRAME TUBE
(9 AND 9B)

Step 2-
ASSEMBLE THE ROOF FRAME USING THE SIDE CONNECTOR TO
CONNECT RIDGES USING (A AND AB)
 

Step 3-
ASSEMBLE THE PAVILION COVER AND PULL THE COVER TIGHTLY OVER THE ASSEMBLED ROOF FRAME

Step 4-
LEG ASSEMBLY
LIFT UP THE CORNER ONE AT A
TIME AND INSERT THE LEG TUBE
 

Step5-
FINAL ASSEMBLY
PULL THE COVER TIGHTLY OVER THE
ASSEMBLED FRAME AND INSERT THE
HOOK INTO THE TOP MOST HOLE OF
EACH LEG. (NOTE: MOVE THE HOOK
TO THE NEXT AVAILAVLE POSITION
WHEN FABRIC IS LOOSE.)
 

Step 5-
Secure the Screen house down by inserting the hooks, #C, located on the outside lower corners of the screen house, to one of the three holes in the leg pole. Secure the screen house to the frame by buckling the tabs, #D, around the poles. Secure the screen house down to the ground by inserting the stakes through the loops and D- rings. The stake loops are located at #E, and the D- rings are located at # F. If you are setting this screen house on a deck or concrete you may hook the D-rings to the plastic base or attach a weight, or sand bag to the D-rings.

Step 6-
Tie the loose end of each guy line to the D- rings located on the top corners of the screen house roof, #G. On the other end of the guy line extend the loop and stake it 3ft from the corner base of the screen house. Adjust the tension of the guy line with the slider. You may also tie the guy lines to a tree or fence for extra support.