|
Canopy with
Screen Shade 10'x12'
90251/90252 |
|
|
| |
Part No. |
Description |
Qty. Req. |
| 1. |
 |
Peak Center Pole |
1 |
| 2. |
 |
Shock Corded Roof Pole |
4 |
| 3. |
 |
Supporting Pole #8 |
2 |
| 4. |
 |
Supporting Pole #7B |
4 |
| 5. |
 |
Shock Corded Eave Pole 10' Side |
2 |
| 6. |
 |
Shock Corded Eave Pole 12' Side |
2 |
| 7. |
 |
Leg #6B |
8 |
| 8. |
 |
Leg #6 |
4 |
| 9. |
 |
Roof End Hub |
2 |
| 10. |
 |
Eave Corner Connector |
4 |
| 12. |
 |
Base Plate |
4 |
| 13. |
 |
Steel Stake 8" |
20 |
| 14. |
 |
Guy Lines |
4 |
| 15. |
 |
Fabric Skin |
1 |
| 16. |
 |
Carrying Bag |
1 |
|
Step 1-
Lay out all the parts. Connect all the Shock Corded pole sections
together. Lay out all the shock corded eave poles as shown in Diagram 1.
Insert the eave poles into the cave corner connectors.
|
|
|
|
Step 2-
Assemble the Peak Center pole (1Y) with the Roof end hub and the Roof
end hub. Then attach the Shock Corded roof pole to the roof end hub, as
shown in Diagram 2. Assemble the supporting poles 7B-8-7B together, and
hook it to the eave, and roof center pole. |
|
Step 3-
Spread the screen house skin flat on the ground. Unzip all the doors for
easier setup. Drape the screen house skin over the roof poles of the
frame, pull the skin till taut from corner to corner. Buckle the straps
inside the screen house around each eave pole. |
 |
|
|
Step 4-
Connect the leg poles into the eave corner and center connectors to
raise the screen house, see Diagram 4. When installing legs please
install the 12 ft. side first by raising each the legs (6B) one at
a time. Make sure that leg #6 is the closest to the ground. Insert the
plastic base plate onto the leg ends as shown in Diagram 4.
|
|
Step 5-
Secure the Screen house down by inserting the hooks, #C, located on the
outside lower corners of the screen house, to one of the three holes in
the leg pole. Secure the screen house to the frame by buckling the tabs,
#D, around the poles. Secure the screen house down to the ground by
inserting the stakes through the loops and D- rings. The stake loops are
located at #E, and the D- rings are located at # F. If you are setting
this screen house on a deck or concrete you may hook the D-rings to the
plastic base or attach a weight, or sand bag to the D-rings.
Step 6-
Tie the loose end of each guy line to the D- rings located on the top
corners of the screen house roof, #G. On the other end of the guy line
extend the loop and stake it 3ft from the corner base of the screen
house. Adjust the tension of the guy line with the slider. You may also
tie the guy lines to a tree or fence for extra support.
|
|
|